Ecotech Vectra L2 question

  • Thread starter Thread starter Empire
  • Start date Start date
  • Tagged users Tagged users None

Empire

Active Member
View Badges
Joined
Feb 6, 2014
Messages
439
Reaction score
232
Location
Charlotte, NC
Rating - 0%
0   0   0
Hi - does anyone have an L2? How can I use flex hose/tube for this pump? I see an L1 barb online but can I use this for the l2?
 
I have the smallest one and used 3/4 barb and a small piece of 3/4 pvc to attach the barb to a flex hose
 
Sorry I’m away from tank but the piece that comes out of the pump I glued a small length of 3/4 inch pvc pipe then glued the 3/4 inch barb then attached the 3/4 thread inch flex hose to the 3/4 inch barb on the pvc return line. The reason I went with the flex hose attached to the return pump was to stop any vibration noise
 
Take the blue adapter off the pump and take it to your local hardware store and match it up
 
Most home improvement stores have everything you need to plumb a tank minus bulkheads. Hope this helps
 
Threads on the gen 2 are the same as gen 1.
 
Sorry, native threads are the same but the couplers are different. Still should accept a 1 1/4” slip barb though. Perhaps best to call ETM and ask.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new