Seregus
Active Member
- Joined
- Jun 30, 2016
- Messages
- 253
- Reaction score
- 134
- Location
- Como
- What state or country do you live in
- Other International
Greeting everyone,
I have GHL Profilux system with plenty of bits and one of them are two optical level sensors currently used as ‘ATO and AWC’ and I must say it works well with 3 Maxi Doser heads.
Now I just released I could have added a logic about lower sensor is not in a water for say 30 minutes it should trigger low water alarm for my pump, maybe even quicker like 5 minutes.
Currently this sensor is set to “inactive” (its all functioning, I’m talking levels screen of Profilux) and I was thinking switching it to ‘pump’… but not sure if it will keep working in both scenarios? I mean will it keep working for AWC?
Yes I know I can add one more sensor and do return pump low water protection, and I’ve done it with leak sensors and sump high water (skimmer and roller mat protection). So adding more sensors means I have to add a card, which will be my way to go if I can not do the work around with delay…
I have GHL Profilux system with plenty of bits and one of them are two optical level sensors currently used as ‘ATO and AWC’ and I must say it works well with 3 Maxi Doser heads.
Now I just released I could have added a logic about lower sensor is not in a water for say 30 minutes it should trigger low water alarm for my pump, maybe even quicker like 5 minutes.
Currently this sensor is set to “inactive” (its all functioning, I’m talking levels screen of Profilux) and I was thinking switching it to ‘pump’… but not sure if it will keep working in both scenarios? I mean will it keep working for AWC?
Yes I know I can add one more sensor and do return pump low water protection, and I’ve done it with leak sensors and sump high water (skimmer and roller mat protection). So adding more sensors means I have to add a card, which will be my way to go if I can not do the work around with delay…
