GHL Profilux 2 level sensors - third function?

[Seregus]

Greeting everyone,

I have GHL Profilux system with plenty of bits and one of them are two optical level sensors currently used as ‘ATO and AWC’ and I must say it works well with 3 Maxi Doser heads.

Now I just released I could have added a logic about lower sensor is not in a water for say 30 minutes it should trigger low water alarm for my pump, maybe even quicker like 5 minutes.
Currently this sensor is set to “inactive” (its all functioning, I’m talking levels screen of Profilux) and I was thinking switching it to ‘pump’… but not sure if it will keep working in both scenarios? I mean will it keep working for AWC?

Yes I know I can add one more sensor and do return pump low water protection, and I’ve done it with leak sensors and sump high water (skimmer and roller mat protection). So adding more sensors means I have to add a card, which will be my way to go if I can not do the work around with delay…

 

[Lasse]

You can easy use the same sensor to different pump programs

Sincerely Lasse

 

[Seregus]

Yes I understand if I set a function to a level sensor it can trigger multiple pumps.

I have sensor one and two. Number one is set to ATO and AWC with two sensors and second is selected in it’s settings.

Now can I use sensor number two, which is selected in the sensor one settings as ‘return pump’ and using programming logic delay?

I’m afraid setting a function to sensor number two will ruin awc, since its also selected in its settings?

Thank you