Hard plumbing advice?

[AquaJunkie]

I have this Red Sea pipe but it's a bit smaller than the 25mm-3/4" elbow I have..

Does anyone know how I can make the pipe fit in the 45 degree elbow with a tight fitting?

Would teflon tape work or is there something else that can make it fit tightly? Thanks

 

[MtrSkllz]

Is that for the emergency drain?

broadfield has a good write up about how to do it here
https://www.reef2reef.com/threads/show-off-and-discuss-your-red-sea-reefer-series.219309/page-157

but basically you would buy an additional (or 2) return assemblies from red sea that you screw in a 3/4 fitting. and plumb directly into that.

 

[AquaJunkie]

Don't think Red Sea supply separate parts for the e260 so was hoping there was some trick to making the wrong sized pipe fit into this 25mm elbow

 

[AquaJunkie]

Could I not melt the 45 elbow a tiny bit to narrow the hole? As Red Seas fitting is glued down to the pipe.

 

[AquaJunkie]

The outer diameter of red seas pipe is 24mm and the inner diameter of my elbow is 25mm so I'm literally 1mm off but can't any plumbing of 24mm anywhere?

 

[USCG CWO]

https://www.amazon.com/Inner-Degree-Elbow-Design-Connectors/dp/B00NWF7CXS