Help...Red Sea Skimmer

[ksir17]

I have been going through some trouble lately with my Red Sea 300 skimmer. I can't figure out why there is an uneven height of bubbles being produced between the divider of the skimmer neck. In the photo you can see the foam on the left side is about an inch higher than the right. Anyone run into this issue or have a solution?

 

[MarineandReef Jaron]

I am not currently running a RedSea Skimmer but I have in the past and I wouldn't worry about it. Focus on what is being collected. If the skimmate looks good then don't worry about how the bubbles look.

 

[A_Blind_Reefer]

It’s normal and I wouldn’t worry about it. You could turn the neck cleaner in a futile attempt to balance it, remove the neck cleaner some do this, or just don’t care