Help with Gyre/Apex/Icecap

  • Thread starter Thread starter scott11
  • Start date Start date
  • Tagged users Tagged users None

scott11

Active Member
View Badges
Joined
Jul 30, 2011
Messages
129
Reaction score
40
Location
Arizona
Rating - 0%
0   0   0
I purchased a gyre/icecap setup to use with my Apex. Its my first time using a Gyre. It has the "Y" cord plugged into the V3/V4 port on the apex. When I power up the gyre, the icecap runs through the startup routine and spins the prop, so I know I have power and the blades work. But, after the startup, it does not respond to the Apex. I am unsure if it is hooked up to V3 or V4, so in both spots I have this coding:

Fallback ON
Set GyreSpeed

For GyreSpeed I have the following:
Sync and Divide not checked
Initial Time 1
On time 10
Off time 10
Min 80
Max 100


Any ideas what I am doing wrong?
 
Got it working. Needed to switch to the other wire on the Y. Not sure why it worked.
Can I ask what icecap you bought ? We are upgrading our tank and recently bought an apex system and want to run gyres with it . That is how I found this post ? Thank you
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new