I purchased a gyre/icecap setup to use with my Apex. Its my first time using a Gyre. It has the "Y" cord plugged into the V3/V4 port on the apex. When I power up the gyre, the icecap runs through the startup routine and spins the prop, so I know I have power and the blades work. But, after the startup, it does not respond to the Apex. I am unsure if it is hooked up to V3 or V4, so in both spots I have this coding:
Fallback ON
Set GyreSpeed
For GyreSpeed I have the following:
Sync and Divide not checked
Initial Time 1
On time 10
Off time 10
Min 80
Max 100
Any ideas what I am doing wrong?
Fallback ON
Set GyreSpeed
For GyreSpeed I have the following:
Sync and Divide not checked
Initial Time 1
On time 10
Off time 10
Min 80
Max 100
Any ideas what I am doing wrong?