Spectrapure manufacturers the only tested and proven low waste RO/DI system on the
market with their MaxCap UHE. Others have tried and given up years ago. In the past they attempted to flush the membrane with tap water and Spectrapure has gone a step further by using a microprocessor and stored DI water to flush the membrane for long life. It also pickles or stores the membrane in DI when its not in use so it is drawing the contaminants out and TDS creep is no longer an issue since its DI inside the housing not tap.
It is capable of over 100 GPD at 1:1 waste ratio or less, I run at 0.67:1 myself or less than 1:1 in Phoenic with a tap TDS over 500. I tested my system last weekend and found the following after 26 months of heavy usage:
Tap TDS 537
RO only TDS 2.2 (using a handheld COM-100 TDS meter)
MaxCap DI - 0 TDS, this cartridge was replaced for the first time on 5/27/10 after 19 months of use before it started to show a TDS reading.
SilicaBuster DI- 0 TDS, and thats still the original SilicaBuster cartridge from 26 months ago, never been changed!
They are not cheap but they are the only system like it today.
Dual membrane systems still must be run at 4:1 waste ratio if you expect the second membrane to last. Remember it is receiving the brine from the first membrane at 20 to 25% higher TDS than the tap was to begin with. If siomeone os promoting it as a wate rsaver you might want to investigate further, its been tried and forgotten by all the major players years ago. Note AWI. Buckeye, Spectrapure, PurelyH2o and many others all sell dual membrane systems but not one promotes it as a water saving system, only a faster system. I suppose if you have Tap TDS of 50 ot 100 it would work for awhile but will still fail sooner than a properly flushed membrane. Its simply not a good idea.