HOB and QT tank

  • Thread starter Thread starter KyleC
  • Start date Start date
  • Tagged users Tagged users None

KyleC

Active Member
View Badges
Joined
Mar 7, 2023
Messages
330
Reaction score
197
Location
Northern Ireland, Belfast
Rating - 0%
0   0   0
I have a QT tank setup, 20g with a HOB, heater and an airstone. When doing water changes I changed the sponges... is it better to just rinse the sponges in QT water so as to keep the bacteria? I had been changing them to new ones but now I'm thinking this removes too much of the bacteria?

Asking because I just lost my chromis, no obvious illnesses.. it was only him in the tank. On checking parameters everything was good apart from ammonia which was reading around 0.2mg/l. Ammonia badge showing fine.

I'm going to bleach everything and dry then start my QT tank again using some sponge from the DT, but I want to know how best to increase bacteria in QT when I can't use rock or sand to avoid this happening again.

This is the hob I use HOB
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new