Horizzontal External ATS 3D Printed

[stefano18]

Hello everybody !

I wanna show you my new prototype about an Horizzontal Ext. ATS, made whit my 3D printed.

The surface for the algae is about 8000 mm^2. I'd use this filter for a Nanoreef, about 50 L, 13 Gal.

The length is 134mm, but i can extend this one, to 200-300mm. It depends if i can find someone whit a big 3D printer :rolling-on-the-floor-laughing: .

I used PLA, all the screws and nuts are made in PLA, except those out water.

The light is a simple 4 LED full-spectrum, maybe something like 4 o 5 Watt..


I should print the PLA net, to algae's support. But i'm looking for something to different of a plastic net, any suggests?

And.. That's it..

So, what do you think..?

It's for fun, if it doesn't work, is not a problem, i spent about 3-4€ of plastic.
but it could work !

ATS Prototype 3D printer

Enjoy the videos and music you love, upload original content, and share it all with friends, family, and the world on YouTube.

www.youtube.com

Here you can watch the filter. (momentaneously is on Sweet Tank)



P.s I'm gonna upload the STL file, if someone wants to print it!

 

[blaxsun]

I wasn't expecting a "waterslide". Neat! :beaming-face-with-smiling-eyes:

 

[stefano18]

I wasn't expecting a "waterslide". Neat! :beaming-face-with-smiling-eyes:

you're right.. It's a waterslide... :rolling-on-the-floor-laughing:



But in this way i hope the water stays inside the filter, it's not easy it goes out whit this filter geometry..


Anyway, i've got a new version in my mind, whit 15cm*15cm Area, absolutely bigger than this.

I wanna see if it works, before to print a new bigger version!