Wow, I woke up to a flurry of messages! :)
Nice to see a fellow KC reefer :) The fact that you go weeks between trips tells me that you probably don't have any defective equipment but in the "perfect storm" you are overloading the circuit. I mean all your devices are drawing current at the same time.
Welcome to R2R btw :)
Thanks Krash! Although I've been here for about 10 years now. But I mostly used ReefSanctuary back in the day (because they had a specific Red Sea Max Owner's forum, which is what I had / still have). I lost interest in the hobby for many years after a crash and this February I got back into it and upgraded to a 120g. Anyway, what part of KC are you in? I'm in Blue Springs.
This is my thought as well. If it's happening really intermittently it's usually a point where for whatever reason everything is turned on at once and it's too much for the circuit.
Thanks, I had been wondering that as well. But I figured it would blow the breaker vs trip the GFCI - something I don't know a lot about though. By far the biggest power draw is my 500 watt heater. So if I put it on a separate GFCI outlet, maybe that alone would fix the issue?
Or a gfci going bad. How old is it?
Newish - I installed it in February or March of this year. Very bad planning on me though - I installed it behind the tank and it may be impossible to replace now. :(
Many variables. Old gfi? (notice I didn't say gfci lol) Other outlets on the circuit? You can get cheap power loss alarms at the hardware store to be safe until you get it sorted out.
The Apex Heartbeat alerts me when the power goes out (although it takes a half hour to do so).
Do you have the Apex ATO and a classic Apex head unit?
Nope, 2016 Apex and using Genesis Reef Systems STORM and RENEW ATO and auto water change system. That said, I did have a cheap supplemental powerhead that I know was tripping the GFCI occasionally (it would immediately trip sometimes right when I plugged it in). I quit using that though.
A single GFCI receptacle is never a good idea. At least keep your return pump on its own GFCI receptacle, separate from anything else. Remember new GFCI receptacles are self testing, when they go bad they shut themselves off.
Well, but I run everything off of my Apex EB832. That said, I have my MP40 on a battery backup to make sure there's flow in the tank if the power goes out. Also, I have an EB8 that I might hook up to a different GFCI outlet. I'll see if I can hook it up to a separate breaker as well, so I don't have everything on the same breaker. Maybe like this:
Breaker/GFCI 1: EB832: Most Equipment, MP40 with Battery Backup
Breaker/GFCI 2: EB8: Return pump, Heater. Then the biggest power draw [heater] is on its own, with the return pump, and if one breaker goes down, I'll still have flow.
Thoughts?
I like the power monitoring of the EB832 (showing how much power draw each device takes). IIRC the EB8 doesn't report that? I'll have to check... Thanks,
--Kyle