Installing BRS water saver membrane kit

  • Thread starter Thread starter Snoopdog
  • Start date Start date
  • Tagged users Tagged users None

Snoopdog

Valuable Member
View Badges
Joined
Apr 23, 2018
Messages
1,646
Reaction score
1,176
Location
Mobile, AL
Rating - 0%
0   0   0
I installed the BRS water saver kit to my 6 stage BRS RO/DI system. I had the pressure gauge before the first membrane and it read 75 PSI, I do not have a booster pump. This morning when I got up I heard a loud noise from where the RO/DI is installed under my sink. The gauge is glycerine filled and was bouncing back and forth, like from water hammering or something. It seemed fine last night. The water coming into the RO unit when this noise occurs is at 75psi. The noise seems to be coming from the auto shutoff valve, it will bounce around in your hand. I have went back and checked the video and it appears I have everything plumbed correctly, both membranes are new.
 
I think I know what is causing this after reading. My membrane came in damaged but I did not worry much about it. It appears that fitting is actually a check valve and I just used a fitting from my bag of spare parts, could this be causing it? If it is the problem I need to call BRS.

20230827_121440.jpg
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new