Kamoer FX-STP PERISTALTIC CONTINUOUS DUTY DOSING PUMP

  • Thread starter Thread starter xabo
  • Start date Start date
  • Tagged users Tagged users None

xabo

Valuable Member
View Badges
Joined
Aug 21, 2009
Messages
1,203
Reaction score
592
Location
Wash. D.C.
Rating - 100%
2   0   0
Can someone explain how to set up a Kamoer FX-STP to pull water through a Geo CR612X2 Cx reactor and what additional parts are needed? Thanks
 
Can someone explain how to set up a Kamoer FX-STP to pull water through a Geo CR612X2 Cx reactor and what additional parts are needed? Thanks

I would recommend emailing our friendly support staff at [email protected]. I am confident they can get you going in the right direction!
 
The pump has an input side and an output side. You just need to connect the input side of the pump to the OUTPUT side of your CaRX. The alternative would be to connect the output of the pump to the input of the CaRX.
 
This is how I set mine up on the new sump. I used hard 1/4" pipe to draw from the sump it goes to the ca/rx, on the output side of the reactor goes to the kamoer. And then returns to the return chamber and drips from there

20191205_151428.jpg
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.5%
  • Fish or coral food

    Votes: 5 5.4%
  • Test kits or reagents

    Votes: 10 10.9%
  • Filter media or replacement fleece

    Votes: 5 5.4%
  • RO/DI filters or supplies

    Votes: 14 15.2%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 10.9%
  • I keep a backup of everything

    Votes: 24 26.1%
  • Other (Post in the comments)

    Votes: 7 7.6%
Back
Top
Home
Post thread…
Market
What's new