Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Bad gaskets or overtightened gaskets likely. In my case, I could not disassemble plumbing so had to recourse to this BUT it worked !!I really considerd silicon. maybe the old gaskets were bad.
Nut should not be submerged and should be on dry side of tank. Gasket placed over threads pushed up to flange side of bulkhead goes on wet/submerged side of bulkhead. There is no need for pipe dope or teflon tape if it is put on correctly.Are you sure it’s not leaking through the threads. Had a similar problem last month. Thought it was gasket but was poor fit between nut and threads. Used pipe dope instead of Teflon tape. Messy as heck but no more leak
Both of these are correct. Just make sure it is 1".so this is ok for my needs 1 inch slip x slip bulkhead
https://www.saltwateraquarium.com/schedule-40-bulkhead-1-slip-x-slip-black-hole-size-1-3-4/
the hole size is throwing me off. I need it to be the exact same as
https://www.bulkreefsupply.com/bulkhead-abs-slip-x-slip-1-7c63a554c36ea63c77723a472b7ca20f.html
thank you i will order them now. I am ordering 4. I had to replace my gates valves too since i glued them in. lesson learned make sure u get a seal before gluing gate valvesBoth of these are correct. Just make sure it is 1".