Leyth's Deep Blue Rimless 60 gallon cube

Leyth · Sep 27, 2012

Hey guys I picked up my tank and stand yesterday and made a short video highlighting a few of the tank's features. I gave it a brief high level review. Hopefully this video proves useful for some! Thanks for watching! Any advice would be welcome.

Leyth's Deep Blue Edge Rimless 60 gallon Video 1 - YouTube

AsphaltPays · Sep 28, 2012

Hello and Welcome to R2R I own two Deep blue tanks 90 and a 60 gallon frag tank and my only complaint is the overflows I changed them out for mega flow overflows and could not be happier You need all four of those gaskets one set for inside and one set for outside of the overflow if not it will leak

Sent from my iPhone 4S using Tapatalk

Leyth · Sep 28, 2012

oh I see, I thought we only used the gaskets on the inside. I dunno where I heard that. Why did you not like the overflow?

Leyth · Sep 28, 2012

Oh you were referring to the plumbing inside the overflow.

Leyth · Sep 28, 2012

Hey I was looking for the MegaFlow Overflow kit, but the sizes on the bulkheads do not seem right. It says it comes with a 1" and a .75", but I thought the Deep blue Edge cube had a 1.5" and a 1". Am I wrong?

Leyth · Sep 29, 2012

AsphaltPays said:
Hello and Welcome to R2R I own two Deep blue tanks 90 and a 60 gallon frag tank and my only complaint is the overflows I changed them out for mega flow overflows and could not be happier You need all four of those gaskets one set for inside and one set for outside of the overflow if not it will leak

Sent from my iPhone 4S using Tapatalk

After some research, I can't find anyone that puts the gasket on both sides of the glass when installing the bulkheads.

revsgirl · Sep 29, 2012

Nice setup! I'm following!

Leyth · Sep 30, 2012

Hey thanks for your support, I am going to try and be as detailed as possible. Starting with this post:

Well I had a large detailed question to ask, but I seemed to have answered it by doing the research. I wanted to run schedule 80 bulkheads, but I don't think it is going to happen. The 1" schedule 80 bulkhead requires 1 7/8" of a hole, and even though I am really close, it doesn't look like one will fit. I will leave these pictures up anyways for future research purposes.

Drain:

Return: