Maxspect gyre problem

Eddie7144 · Jan 30, 2018

Hey all, ok so here is the problem. I added another fx250 to my tank, so I set up both fx250 pumps and theubwere running fine. Now I'm not sure if did something to the program but pump A turns off by it's self and pump B keeps going. If i turn the controller off and on they both run and after a few pump A turns off again. What am I missing here ?? Or doing wrong ?

BigHildy53 · Jan 30, 2018

Are you using the advanced controller? Can you send a picture of the controller setup?

Eddie7144 · Jan 30, 2018

BigHildy53 said:
Are you using the advanced controller? Can you send a picture of the controller setup?

Yes it is the advanced controller, I've had it for a month,

roberthu526 · Jan 30, 2018

There are patches to fix this issue. Just go to coralvue website support section and you will find instruction. I am surprised that they still haven't fixed the controller yet. Not sure why they wouldn't just install the latest firmware when the new controllers are manufactured.

Hoyhoy · Jul 9, 2018

Sorry to pump an old thread but did the patch solve your issue @Eddie7144. Which version in your controller when you encountered the issue? (mine is currently 1.7)

Thanks.

Eddie7144 · Jul 11, 2018

Hoyhoy said:
Sorry to pump an old thread but did the patch solve your issue @Eddie7144. Which version in your controller when you encountered the issue? (mine is currently 1.7)

Thanks.

Turns out i had a defective pump. Got it replaced , now everything works like a charm !