All right, apparently I'm missing something...
I ran the RJ45 upstairs and plugged the Lightbar splitter into the ProfiLux (first into the second outlet on the main unit, then into the PowerBar).
And the ProfiLux thinks it is running the lights. In Myghl is see the channels there and see them shifting. But it isn't changing the lights at all. They are just running at 100%.
Lots of fiddling and trying and retrying the steps but no luck. In the end I just plugged them back into the ProfiLux Light and they started behaving as expected again right away.
I should add that when I first switched them over, and added the new Deep Actinic, they kind of freaked out.
The went on at 100% (I think ) then went off. Then started pulsing red! The faded back to full spectrum, the pulsing red again. They kept doing that until I had loaded my profile and transmitted it. Then they stopped and just stayed on at full spectrum.
Also doing the Test Spectrum had no effect either.
So.... @Marco@GHLUSA, @Lasse, @Ditto ...
Help?
Cheers, Tony
I ran the RJ45 upstairs and plugged the Lightbar splitter into the ProfiLux (first into the second outlet on the main unit, then into the PowerBar).
And the ProfiLux thinks it is running the lights. In Myghl is see the channels there and see them shifting. But it isn't changing the lights at all. They are just running at 100%.
Lots of fiddling and trying and retrying the steps but no luck. In the end I just plugged them back into the ProfiLux Light and they started behaving as expected again right away.
I should add that when I first switched them over, and added the new Deep Actinic, they kind of freaked out.
The went on at 100% (I think ) then went off. Then started pulsing red! The faded back to full spectrum, the pulsing red again. They kept doing that until I had loaded my profile and transmitted it. Then they stopped and just stayed on at full spectrum.
Also doing the Test Spectrum had no effect either.
So.... @Marco@GHLUSA, @Lasse, @Ditto ...
Help?
Cheers, Tony