mh0ward
Active Member
Hey everyone, I got my first anemone earlier this week and designed a new nozzle for my MP10 to hopefully guard against it getting sucked in, should it ever decide to move. I uploaded the STL to thingiverse in case anyone else wants to give it a try. MP10 Anemone Guard STL
I did design the hole where the ceramic shaft of the frame inserts just a bit small. This was intentional so that I could slowly file/sand the inside of the hole to ensure a tight fit (prevent vibration, noise, etc). Here's what the finished nozzle looks like after spending a fair bit of time plucking away the support material and light sanding.
I did design the hole where the ceramic shaft of the frame inserts just a bit small. This was intentional so that I could slowly file/sand the inside of the hole to ensure a tight fit (prevent vibration, noise, etc). Here's what the finished nozzle looks like after spending a fair bit of time plucking away the support material and light sanding.
