Glass thickness?
And is the dry side supported? If the dry side is supported, only the wet side should fall off if the glass is too thick.
And is the dry side supported? If the dry side is supported, only the wet side should fall off if the glass is too thick.
RSREEFING
Active Member
It's on a IM 50 lagoon. The dry side isn't supported because I'm still trying to find a good spot for it.
I also have another mp10 on the other side that's not supported but that one hasn't run into any issues.
10mm glass, thats fine for an MP10. FWIW ecotech says they will not work on anything over 9.5mm, but my tank is 12mm and as long as I support the dry side, they stay coupled and do not fall off if I stay under 90%.
Whether they stay from not being supported or not, read the direction. The dry side should be supported with a sticky "puck" and cable tie that sticks to your glass. this keep them coupled, and from falling off the glass.
If my dry side is not supported, both sides fall off when on 90% intensity in any mode, But my glass is supposed to be to thick for mp10's.
Whether they stay from not being supported or not, read the direction. The dry side should be supported with a sticky "puck" and cable tie that sticks to your glass. this keep them coupled, and from falling off the glass.
If my dry side is not supported, both sides fall off when on 90% intensity in any mode, But my glass is supposed to be to thick for mp10's.
FYI if your moving them around to try and find the best placement. You can buy a whole pack of those sticky pucks from lowes for about $5.
Similar threads
