alex77619
Active Member
- Joined
- Mar 1, 2018
- Messages
- 279
- Reaction score
- 308
- Location
- Victoria
- What state or country do you live in
- Texas
So I have a MP40WES working fine for a month, I recently just clean the wet side.
After I try to connect it to my WXM and the WXM can never attach it.
I went and try to update the controller driver. It went through the update successfully. But after I power it down and turn back on. It only run a sec and start flashing red.
I try the method of clearing the power test failure (Holding Mode than holding both mode and set.) but it won’t do anything but keep in the flashing red. I went ahead and reupdate the driver with no problem but after power off and power back it’s still blinking red.
Does anyone have any thoughts for me to try and fix it?
After I try to connect it to my WXM and the WXM can never attach it.
I went and try to update the controller driver. It went through the update successfully. But after I power it down and turn back on. It only run a sec and start flashing red.
I try the method of clearing the power test failure (Holding Mode than holding both mode and set.) but it won’t do anything but keep in the flashing red. I went ahead and reupdate the driver with no problem but after power off and power back it’s still blinking red.
Does anyone have any thoughts for me to try and fix it?
