My 2nd ICP

  • Thread starter Thread starter PeterEde
  • Start date Start date
  • Tagged users Tagged users None
What you dosing for nitrates that you think it makes your phosphates rise?
 
What you dosing for nitrates that you think it makes your phosphates rise?
Phosporus. NO3 was not moving using NOPOX due to no detectable PO4.
Since dosing P my NO3 is down to 23 from 40+
Also could be due to increased macro since I also have a refugium going too.
No reactors, skimmer only
 
Phosporus. NO3 was not moving using NOPOX due to no detectable PO4.
Since dosing P my NO3 is down to 23 from 40+
Also could be due to increased macro since I also have a refugium going too.
No reactors, skimmer only
No that’s the right move, I just didn’t add up, did you recently dose anything for your macro algae to grow? Like chaeto grow or similar?
 
I have cheato and culerpa. No added nutrients but Culerpa has gone nuts from one stem
I was wondering if you had done it, could explain the high fe although if the algaes are growing again it should go down again.
 
I was wondering if you had done it, could explain the high fe although if the algaes are growing again it should go down again.
I use aqua forrest salt. The Fe might be from that. There was some questions raised over Fe content in this salt before
 
The calcium is fine.

IMO, unless you measured the salt mix itself, iron is not super likely to be from a salt mix as it is used or precipitated fairly fast. The actual iron level you report is fine anyway. Some folks recommend substantially raised levels.
 
The calcium is fine.

IMO, unless you measured the salt mix itself, iron is not super likely to be from a salt mix as it is used or precipitated fairly fast. The actual iron level you report is fine anyway. Some folks recommend substantially raised levels.
Thanks Randy
Always appreciate your thoughts.
I will dose iodine and not worry about the rest. Por a hora
 
So looking at my ICP I can see the Redsea titration is not the be all that a titration should be.
Mg is 200ppm high at least
Ca shows high

Are there home tests more accurate than the Redsea kits?
Or instead of wasting money on test kits would it be cheaper long term to just do ICP every 2nd month and dose accordingly

Should I invest in Hanna PH and Alk testers
 
Are there home tests more accurate than the Redsea kits?
Or instead of wasting money on test kits would it be cheaper long term to just do ICP every 2nd month and dose accordingly

Generally people find that red sea Mg reads a bit high and Salifert reads more in line with expected .
Red sea Ca seems fine according to most.
Titration kits are very consistent which is what's important for tracking trends to dialing in dosing amounts. Whether a kit reads a little high or low is less important.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new