Need a replacement for this

[Stylo328]

Hello,

I need a replacement for this part. Is there an easy way to get it?

Thanks!

 

[justingraham]

Unscrew the back and push the wire back up into the controller.
Home Depot sells grommets u could use. Now if the wire is broken pretty sure u will have to buy the whole dry side. Unless ur good at soldering

 

[Stylo328]

It's the grommet that I need. Was hoping to get the original from eco-tech. The pump works perfectly fine, just need to replace that part.

Thanks

 

[Stylo328]

Actually, thinking of it, there is a multi-pin connector at the end of that cable (if wired the same as non-QD). Don't think I could get a geometry on there.

 

[justingraham]

I think the grommets are cut aren't they?

 

[sn2per]

I've used a heat activated tape before now works like shrink wrap but in a tape form... I know I'm in the UK but if can find it you may be able to purchase something similar... I'll have a look now.

 

[sn2per]

Here you go... stateside as well...

http://www.cableorganizer.com/adhesive-heat-shrink-tape/

 

[AdamNC]

I've used this stuff before with good success.
https://www.delcity.net/store/Liqui...ign=Shrink+Tube+&+Tape&utm_keywordmatchtype=b

 

[Stylo328]

Thank you both very much. That was very helpful!