I’ve really been through the ringer this week with my equipment!
The latest is that my Trident (connected via power cord and aquabus) gets as far through the setup process as the light turning blue...then it turns orange and just keeps blinking —- it’s going on 2 hours now. I’ve tried different Aquabus ports, and different Aquabus cables. Once or twice it went red. What can I do?
By the way, the reason I’m not using a 1 Link is bc I tried that, and the unit did the same thing (stuck on blinking orange) had also lit up red a few times. Upon inspection, one side of the 1 Link is missing that little tab underneath the holes that you plug in — would that cause an error?
Either way, I can’t get past the orange blinking light.
Thanks,
The latest is that my Trident (connected via power cord and aquabus) gets as far through the setup process as the light turning blue...then it turns orange and just keeps blinking —- it’s going on 2 hours now. I’ve tried different Aquabus ports, and different Aquabus cables. Once or twice it went red. What can I do?
By the way, the reason I’m not using a 1 Link is bc I tried that, and the unit did the same thing (stuck on blinking orange) had also lit up red a few times. Upon inspection, one side of the 1 Link is missing that little tab underneath the holes that you plug in — would that cause an error?
Either way, I can’t get past the orange blinking light.
Thanks,