Where are the darn dip switches to set when adding a 2nd DC8 Energy Bar? Do I have to remove the cover of the power bar, I've looked everywhere... Help!
There are none you add the additional DC8 via a USB cable then login to your system and go to:
Configuration> Module Setup and half way down you'll see: Add Module>DirectConnect(DC8) then to right of it is: Start Control Address, make it (A2) then choose ADD MODULE.
you will see it appear below on the the same page under: Apex Module List
[h=3][/h]Ensure that you have the 2nd DC8 daisy chained to the 1st DC8 before configuring the 2nd DC8. Theres no need for jumpers anymore:bigsmile:
Hope this helps.