Tank 1- 300 gallon water volume
Tank 2 - 85 gallon water volume
Sump 95 gallons water volume in a 150 gallon sump size
Had a Display refugium, removed it for it was not easy to maintain and looked dirty.
In January I got back from Holiday after a 45 days, I came back to a tank with a ton of hair algae and with over 500 gallons of water volume, tearing the tank down was not in the cards at that time.
- My first step was to use a syringe with a fine needle and use H2O2 spraying the algae for over 10 days, this help burn the strands that were fine, difficult to manually remove it by hand.
In areas where I could not reach, the H2O2, helped me burn the algae. Used filter floss to catch the loose debris.
- The second step was to use fluconazole treatment. I was lucky that I had pick up 50 tables of 200mG from Thailand when I was there for $10.00, Wish I had pick more up. This treatment went for 6 days, with H2O2 treatment too.
- The third step was to turn the skimmer, and that made the skimmer over flow, That was great for water change.
As the skim was wet and over flowing, I replace the tank with fresh made water, which I filled in the Display. This took over 4-5 hours to replace the water I lost in the wet skim.
The skimmer stabilized, only putting out dry skim, but still putting out quite a bit of skim, white, frothy but clean.
By the end of the day everything stabilized. By this time I had replaced over 60 gallons of water.
- Now with the skimmer hardly pulling any skim, still white but dry, it was to take readings of the Nitrates and Phosphates. They were high! P04 at 1.83 and nitrates over 120, even with the water changes.
- The fourth step was to reduce the nutrients, this was done with Brightwell Phosphate E and a mixture of Sugar/Vinegar/ Vodka mix. This mix was made with 10 ounces of Vodka, 3 tables spoons of sugar and 30 ounces of Vinegar and about a litre of water, concentrated, made i a jug to be used over a month.
Two separate containers were used as you see in the video.
The VSV mix went into the tank in the water overflow, at the rate of 20 drops/minute, the mix was 200 mLs of the concentrate, topped of with RODI water in the Jug.
The Phosphate E mix was made of 50mLS topped of with RODI waster and this was dripped at 30 drips/minute directly in to skimmer VIA the air intake of the skimmer. This is what you see in the video.
This lasted for a month, slowly, the skimmer now after 2-3 days produced dark green, brown sludge, dry skim slowly but certain days was heavy but not enough to worry, the waste went into a 5 gallon oil jug that I had, this need to be emptied every week, fowl smelling and thick.
- The fifth step was to take reading every 3-5 days, this was to help adjust the drips of wither the PO4 and the Nitrates, as not to strip the tank fast. When the reading went to 0.5 for Phosphates and 60 for the Nitrates, the container for the Phosphate E was discontinued as that jug ran empty.
Now I run the VSV solution, diluting it every time I had to refill the jug, taking the readings as I went along, adjusting the mix and the drips
As of last week, the PO4 reading are at 0.02 and the Nitrates are at 10-20 and still dropping, as I still use a maintenance dosing of VSV mix, but now in the 1 Gallon jug you see, I use 2 Tablespoon of sugar, 4 ounces of Vodka, and 16 ounces of Vinegar, dripping into the tank at the Rate of 1 drip every 6-8 seconds and that jug lasts me close to 5-7 days as the drip is adjusted with the reading taken every week.
I did not have to tear the tank down, took time to rid of all the algae, the rock are still slightly green, and getting better as days go by, did not have to worry about the parameters being dropped down fast. took time to do so but being housebound with COVID, there was plenty of time to monitor the tanks and take reading every 2-3 days, learning how to dose the tank slowly.
Now that go on holidays, if there is one in the near future with COVID, I am slowly perfecting the dose of VSV, for dripping into the tank.
Skimmer SRO Reef octopus 6000 external Skimmer, for I don't have the patience to worry about the water level fluctuations, and it has a variable pump feed, this it to make sure I don't over strip the water as the feed can be adjusted from 800 gallons/hour to 1300 gallons/ hour as to adjust the flow into the skimmer for heavy or light skimming, Just have adjust the knob for the water exiting the skimmer.
Guidance and Feedback appreciated.
https://www.dropbox.com/sh/a6ffwkqwc9wnd74/AACh43jZL5uqe7QBfEt002ria?dl=0
Could not upload the videos, use the link