Opus G2 300 Pro line

[drewtx1]

Mine doesn't do this either, weird, wonder if the top was warped and maybe you didn't notice? Can't imagine its sagging after the fact.

It's possible, i didnt check each piece for being squre while being assembled. I'm baffled by it. I have a 2 foot and 4 foot level. Took my time checking everything when setting it up. I do like the stand that comes with the tank. And like I said the sagging i just found last week. The seam was what I seen before that's what bothered me.

 

[DiscoStuart]

I didn't contact them, I already know I'll be redirected to BRS, (I had a question before about it and that's what happened) I'm not being negative about them or BRS, but I know how customer support will go. If you look up in my thread about the problem with the axis 90 pump(I did contact customer support about that) and no outcome for the issue. So I'm not wasting my time with this. It's costly but I'm fixing the problem myself.

ugh, that's brutal

 

[RoanokeReef]

It's possible, i didnt check each piece for being squre while being assembled. I'm baffled by it. I have a 2 foot and 4 foot level. Took my time checking everything when setting it up. I do like the stand that comes with the tank. And like I said the sagging i just found last week. The seam was what I seen before that's what bothered me.

Yea very strange, all that aside can't wait to see the new stand. :)

 

[drewtx1]

Well UPS messed up. I was expecting 2 delivery's today, only received 1. Still waiting on top and bottom panels and the front and sides. But atleast the hard part is over.

 

[drewtx1]

Got everything back up. Have to do wire Management again. Also repositioned the smart roller. I did check the top on the nyos stand, was slightly off. Probably that little bit where I had the paper under it. Oh also this stand came from alufab. Was great being able to make changes on the form they sent me and see a real time price of everything.

 

[DiscoStuart]

Can't quite tell from your setup, but would that roller fit in the filter sock section without removing the baffle from the original sump setup?