fancy_fish101
Active Member
Do I need to support the plumbing coming from the overflow? I’m doing bean animal so there are a lot of pvc. But it coming straight down and forward.
Overflow
- Thread starter fancy_fish101
- Start date
-
- Tags
- bean animal over flow plumb
- Tagged users None
Red_Beard
I already did
Yes, I would. If you bump it while cleaning that is a lot of torque on the overflow and bulkhead. Not to mention vibration and whatnot from normal use. That would be a sucky thing to have break...
fancy_fish101
Active Member
How would I go about supporting it? It’s not going on this stand. Ps it’s not done yet.
Red_Beard
I already did
What stand is it going on? Is it similar? If yes, i would drill 3/8 hole and get some stainless all-thread and some straps. Kinds like this:
But with a nut/ washer on either side where it goes through the stand. They make rubber lined ones too, that would be preferred.
But with a nut/ washer on either side where it goes through the stand. They make rubber lined ones too, that would be preferred.
o2manyfish
Valuable Member
Look Into "Clic" Clips - These are all plastic clips designed to hold pipes. You might have to create a spacer to mount them to that then attaches to the stand to create a standoff.
Dave B
Dave B
Red_Beard
I already did
Yep, that would work. Sometimes i get stuck in industrial mode....
These are what he means:
Similar threads
TOP 10 Trending Threads
-
- Sticky
-
- Question
