P4 Powerbar 5.1 Socket S5 stopped working

Users Who Are Viewing This Thread (Total: 1, Members: 0, Guests: 1)

Jeremy Luke

Well-Known Member
View Badges
Joined
Feb 17, 2017
Messages
547
Reaction score
358
Location
Northern VA
Rating - 0%
0   0   0
So I redid my socket assignments on my two Powerbars so that I could directly control my ATO pump as I received my level sensor from GHL today. I removed my return pump from the S5 socket and plugged in my two 300w heaters (connected via a cord) to the S5 socket. The socket will not turn on now. Even if I set it to "always on" The two heaters were previously plugged into the same powerbar on sockets S1 and S2. I tried powering off the powerbar (with the switch) and restarting the controller. This unit is only a few months old. Did it really break somehow? Is there some other way I can try to "reset" the powerbar?
 
OP
OP
J

Jeremy Luke

Well-Known Member
View Badges
Joined
Feb 17, 2017
Messages
547
Reaction score
358
Location
Northern VA
Rating - 0%
0   0   0
Got it. Please discard. I guess reading a manual every now and then might be a good idea. So I guess I'll be needing a fuse :)
 
Back
Top