- Joined
- May 28, 2017
- Messages
- 986
- Reaction score
- 444
I am getting ready to build some containers for transporting coral to shows. My plan is to have a heater and circ pump in each container and run them off a power inverter. I know i can just pump the heat up in the truck and make due but i have everything to make it work so I might as well do it right. I also want to have warm water ready to set up the tank when I get to the show. Not truck temp water.
Has anyone figured out how to pass a wire through a container so it wont leak? I have water proof containers, but cant figure out the wire issue with out the water splashing out of where the wires pass through. Worst case would be through the top and use one of those compression fittings that hold probes in CA reactors. I have a few kicking around. But I would like to keep the top functional.
Has anyone figured out how to pass a wire through a container so it wont leak? I have water proof containers, but cant figure out the wire issue with out the water splashing out of where the wires pass through. Worst case would be through the top and use one of those compression fittings that hold probes in CA reactors. I have a few kicking around. But I would like to keep the top functional.