Peninsula aquarium with both ends built into wall. Need wavemaker suggestions

  • Thread starter Thread starter Amboss72
  • Start date Start date
  • Tagged users Tagged users None

Amboss72

Active Member
View Badges
Joined
May 4, 2017
Messages
273
Reaction score
200
What state or country do you live in
Utah
Rating - 0%
0   0   0
I recently took over a 350 gallon 8’ long tank. Both ends of the tank where built with walls surrounding them. There is no space between the ends of the aquarium and the walls. The tank is picture framed leaving both sides visible for the patients of the client. The tank has a large iwaki return pump with one nozzle on the overflow end and two nozzles on the other end of the tank. I’ve also positioned a large gyre on the overflow end as I’m able to put the gyres magnets inside the overflow. I need suggestions as to what I could use for wave makers on the opposite side of the tank where there is no room for magnets. At this point I just have two nozzles from the return on that end of the tank and they aren’t providing enough water movement. Any ideas would be greatly appreciated.
 
You may be able to DIY an acrylic mounts that hang on the top edge of the tank that can then attach a wave maker to.

you can also add some variable nozzles to your return to help those some
 
I hadn’t thought about the DYI acrylic brackets. That could possibly work. Thanks for your input.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new