I have a used 92 gallon Red Sea aquarium with 16 gallon sump. I’m plumbing the sump into the mechanical room of the house which is directly behind the wall where the aquarium will sit. There in an overflow tower in the center back of the tank which has three outlets. I have an eflux 6010 (1900 gph) which I plan to use for my primary return. I would like to add redundancy to the return pump (i was actually able to pick up a tunze 1073.050 for free.
With only one input into the tank, how do I plump a back up?
My concern is that if I use a t-junction, pump A will be slightly stronger than pump B and force some water back down the other pump B.
Is there a way for my apex to evaluate the function of one pump and if it is not working, switch over to the other? How would I plumb this?
I have pictures if that is helpful
Thanks
With only one input into the tank, how do I plump a back up?
My concern is that if I use a t-junction, pump A will be slightly stronger than pump B and force some water back down the other pump B.
Is there a way for my apex to evaluate the function of one pump and if it is not working, switch over to the other? How would I plumb this?
I have pictures if that is helpful
Thanks