The goal is to control a switched socket by both a timer function and a feed pause (the switched socket controls an eheim feeder).
I setup a timer as below and if I set the socket to timer 1 it works as expected.
I then created a programmable logic that I hoped would make the feeder 2 routine pulse the socket for 1 second (setting the socket to programmable logic 2 did not have the desired effect)
The idea was I could use another programmable logic to OR the timer or Programmable logic 2, then set the socket to this programmable logic.
Any ideas where I went wrong?
I setup a timer as below and if I set the socket to timer 1 it works as expected.
I then created a programmable logic that I hoped would make the feeder 2 routine pulse the socket for 1 second (setting the socket to programmable logic 2 did not have the desired effect)
The idea was I could use another programmable logic to OR the timer or Programmable logic 2, then set the socket to this programmable logic.
Any ideas where I went wrong?
