PVC cement - when is it safe?

DmitryB

Valuable Member
View Badges
Joined
May 26, 2026
Messages
1,440
Reaction score
1,118
Location
Hunter, NY
What state or country do you live in
New York
Rating - 100%
1   0   0
I installed manifold into the main plumbing of my tank. What's a safe wait time before turning on the return pump?? I don't think 24 hrs is practical with this particular thing! It's been about 2 hrs.
 
If you read the instructions on the can, it should be specific about this. Often it's 30 minutes, but don't take my word for it.
 
I only ever give it 30 mins. But I also make sure to wipe off the excessive glues inside and around the edges after connecting.
I tried to do that too, but I'm also an amateur plumber and a professional klutz, so we'll find out tomorrow when the lights are back on!

At least there are no leaks!
 
I usually wait about an hour.
If there is any way to rinse most of the new glued pieces ( except the last 2 connections) I'll go a half hour or so.
I used to help once in a while at a lfs and the owner used to change plumbing occasionally and turn the pumps on in about 10 minutes. But it was a larger water volume than most of us have.
 
What do you mean by "safe"? Safe for no joint failure or leaks or safe because the solvent is not toxic to fish.
I recently glued a bunch of fittings for my Tank, and the glue is off gassing solvent for up to 24 Hours.
 
What do you mean by "safe"? Safe for no joint failure or leaks or safe because the solvent is not toxic to fish.
I recently glued a bunch of fittings for my Tank, and the glue is off gassing solvent for up to 24 Hours.
I was thinking more in terms of toxic. This morning everyone in the tank seems fine, so I think it's worked out. I also put a bit of activated carbon in the drain section above the filter socks, just in case.
 
I usually wait about an hour.
If there is any way to rinse most of the new glued pieces ( except the last 2 connections) I'll go a half hour or so.
I used to help once in a while at a lfs and the owner used to change plumbing occasionally and turn the pumps on in about 10 minutes. But it was a larger water volume than most of us have.
The only two newly glued pieces were the two connections. The rest was cemented days ago. Fortunately everyone this morning seems ok!
 
This is always a question I had. We know that the solvent in Super Glue is not Toxic to Fish or Inverts, but I have no idea if the Solvent in PVC Cement is Toxic and at what level. A joint or 2 is not likely a problem, but say you glued up 20 joints. Should Carbon be run or is the Solvent not a Factor?
@Randy Holmes-Farley
 
I installed manifold into the main plumbing of my tank. What's a safe wait time before turning on the return pump?? I don't think 24 hrs is practical with this particular thing! It's been about 2 hrs.
Is there a line that's aimed at human use for kitchens ECT? Or did u find one that's aimed at aquarium/pool ECT use? Thanks also curious what's the go to brand.
 
This is always a question I had. We know that the solvent in Super Glue is not Toxic to Fish or Inverts, but I have no idea if the Solvent in PVC Cement is Toxic and at what level. A joint or 2 is not likely a problem, but say you glued up 20 joints. Should Carbon be run or is the Solvent not a Factor?
@Randy Holmes-Farley
When I've glued up a couple joints, I don't do anything special. But if I were to glue up a major run on a running system, I probably would wait a extended time, try and rinse out the run, and probably run carbon. So all of the above for major work. Just a couple joints, I never have, and never saw a reaction by any corals.
 
Is there a line that's aimed at human use for kitchens ECT? Or did u find one that's aimed at aquarium/pool ECT use? Thanks also curious what's the go to brand.
I used regular Oatey primer and cement. The advice online ranges from 5 mins to 24 hrs! I waited a little over 2 hrs. That's also what Brian from Innovative Marine recommended. I only had 2 joints that were cemented at the end. I think as stated above, if there were a lot of pieces newly done, I'd probably try to figure out a way to not run it for 24 hrs.
 

TOP 10 Trending Threads

HOW DO YOU HANDLE HOLIDAY DECORATING AROUND YOUR REEF?

  • I decorate the tank or stand

    Votes: 1 3.2%
  • I decorate AROUND the tank or stand

    Votes: 4 12.9%
  • I add one small seasonal touch but keep it very basic

    Votes: 0 0.0%
  • I take a holiday photo, but don’t decorate the space

    Votes: 0 0.0%
  • I leave the reef area as it is

    Votes: 22 71.0%
  • We don’t decorate for the holidays

    Votes: 4 12.9%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new