Randy Holmes-Farley
Reef Chemist
View BadgesStaff member
Super Moderator
Excellence Award
Expert Contributor
Article Contributor
R2R Research
My Tank Thread
- Joined
- Sep 5, 2014
- Messages
- 67,279
- Reaction score
- 63,632
What husbandry would I do in a dream tank? (some of this may look familiar as some was posted elsewhere in other threads)
In terms of water chemistry maintenance, I'd maintain calcium and alkalinity with limewater/kalkwasser (maybe pH limited to pH 8.55 or less to prevent overdose; probably on dosing timer rather than ATO) and a two part (if needed; maybe also pH limited to pH 8.55 or less). I'd like a continuous alk monitor, and if Mindstream or Seneye comes on line with reliable data, I'd monitor ammonia 24/7 and in different system locations (main tank, exit from refugium, etc.) for interests sake.
I would do substantial and repetitive ICP testing of the water to guide dosing and exporting.
There are some ions I would dose essentially independent of measurement because I don't think measurement is particularly useful for them (e.g., iron because it is typically below detection limits; silicate because it depletes so fast).
There are a bunch of ions that I do not consider important at the levels reefers typically have (e.g., lithium, maybe barium, I'd need to think through this list) and I would make no substantial effort to control those either by export or by dosing.
I would likely experiment on the tank over time to re-verify for myself that my longstanding opinions on certain chemicals are not particularly useful if dosed to maintain natural levels, despite the fact that many reefers do. If they showed a positive effect, I'd rethink dosing them. These include iodide and strontium. I'd certainly continue dosing them if they appeared useful to my system.
There are a whole bunch of biologically active trace elements that I'd likely measure and dose which I did not in the past, but which previously tested low in my system (e.g., molybdenum) and I'd likely dose these to roughly NSW levels. I might experiment on these in a variety of ways (e.g., allowing one to go undosed for a long time and then restart and see if anything apparently changed).
I'd probably do automatic water changes, but again, might also experiment on the amount, from none to a couple of percent a day.
As to other "methods", I'd likely do some or most of these that I partly copied from another post:
Ato
Temperature control (temp controller to kick on heaters or cooling system)
Skimmer (for aeration if nothing else)
Rodi unit with inline tds
Nutrient export (macroalgae, gfo, organic carbon dosing, GAC, maybe experiment with organic resins like Purigen)
Might try LED lights to save electricity, but I'm not yet convinced I'd like the look
In terms of water chemistry maintenance, I'd maintain calcium and alkalinity with limewater/kalkwasser (maybe pH limited to pH 8.55 or less to prevent overdose; probably on dosing timer rather than ATO) and a two part (if needed; maybe also pH limited to pH 8.55 or less). I'd like a continuous alk monitor, and if Mindstream or Seneye comes on line with reliable data, I'd monitor ammonia 24/7 and in different system locations (main tank, exit from refugium, etc.) for interests sake.
I would do substantial and repetitive ICP testing of the water to guide dosing and exporting.
There are some ions I would dose essentially independent of measurement because I don't think measurement is particularly useful for them (e.g., iron because it is typically below detection limits; silicate because it depletes so fast).
There are a bunch of ions that I do not consider important at the levels reefers typically have (e.g., lithium, maybe barium, I'd need to think through this list) and I would make no substantial effort to control those either by export or by dosing.
I would likely experiment on the tank over time to re-verify for myself that my longstanding opinions on certain chemicals are not particularly useful if dosed to maintain natural levels, despite the fact that many reefers do. If they showed a positive effect, I'd rethink dosing them. These include iodide and strontium. I'd certainly continue dosing them if they appeared useful to my system.
There are a whole bunch of biologically active trace elements that I'd likely measure and dose which I did not in the past, but which previously tested low in my system (e.g., molybdenum) and I'd likely dose these to roughly NSW levels. I might experiment on these in a variety of ways (e.g., allowing one to go undosed for a long time and then restart and see if anything apparently changed).
I'd probably do automatic water changes, but again, might also experiment on the amount, from none to a couple of percent a day.
As to other "methods", I'd likely do some or most of these that I partly copied from another post:
Ato
Temperature control (temp controller to kick on heaters or cooling system)
Skimmer (for aeration if nothing else)
Rodi unit with inline tds
Nutrient export (macroalgae, gfo, organic carbon dosing, GAC, maybe experiment with organic resins like Purigen)
Might try LED lights to save electricity, but I'm not yet convinced I'd like the look