Red Sea 525 Plumbing Question

  • Thread starter Thread starter RickLRMS
  • Start date Start date
  • Tagged users Tagged users None

RickLRMS

Active Member
View Badges
Joined
Aug 15, 2020
Messages
151
Reaction score
126
Location
Northeast Mississippi, USA
What state or country do you live in
Mississippi
Rating - 0%
0   0   0
I have a Neptune COR-20 that I want to connect to my 525. I’ve read elsewhere a hose should have been included; there wasn’t one. The inside diameter of the barbed fitting that came pre-attached to the plumbing is just over 1/2” 13.5mm). The lower portion of the barbed fitting has an outside diameter of just over 3/4” (21mm). I’m assuming a 3/4” inside diameter piece of vinyl tubing will make the connection, (though flow is restricted to 1/2” by the inside diameter of the fitting). Am I correct on the US market tubing size needed? I realize it might need heated to fit but assume a 1” would be too large. Thanks.
 
I have a Neptune COR-20 that I want to connect to my 525. I’ve read elsewhere a hose should have been included; there wasn’t one. The inside diameter of the barbed fitting that came pre-attached to the plumbing is just over 1/2” 13.5mm). The lower portion of the barbed fitting has an outside diameter of just over 3/4” (21mm). I’m assuming a 3/4” inside diameter piece of vinyl tubing will make the connection, (though flow is restricted to 1/2” by the inside diameter of the fitting). Am I correct on the US market tubing size needed? I realize it might need heated to fit but assume a 1” would be too large. Thanks.
How did you end up connecting the COR 20 to your tank? I just got both and are on their way and would like to know what else I need to connect these 2.

Thanks!
 
How did you end up connecting the COR 20 to your tank? I just got both and are on their way and would like to know what else I need to connect these 2.

Thanks!
I used one of the Neptune-supplied adapters into 3/4" PVC, into a 3/4" slip X threaded union, into a threaded barbed fitting, then to 3/4" braided vinyl tubing to connect to the barbed fitting on the Red Sea supplied return line's barbed fitting. I used a hose clamp on the return line but did not use a clamp on the pump side. I have a heat gun that I used to heat the tubing and the bottom fit was very tight without the clamp. I bought the items that I used from Bulk Reed Supply, excerpt from order below along with a photo. I'm no expert (first tank) but I'm happy to answer anything I can. Good luck!

Edit: Of course you will need PVC prep and glue for the slip fittings; I just got those at a local hardware store.


1645033567814.png
Return.jpg
 
Last edited:

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 19 27.9%
  • I’d trust someone who knows my tank to choose

    Votes: 2 2.9%
  • I’d rather get a gift card and pick it myself

    Votes: 26 38.2%
  • I’d prefer gear or supplies instead

    Votes: 2 2.9%
  • Please don’t surprise me with livestock

    Votes: 19 27.9%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new