Yes. For me this worked just fine, as the pwm signal is derived from vcc, and I expect current draw by kessil less than 100ma. We power Raspberry with 2.5 amp connection, Pi uses around 1Amp, rest is for these use cases.
Yeah, lot have changes since then :-) I'll request waiting for couple of days more, till I merge the last dynamic channel/jack patch. After that the configuration file should not matter a lot, otherwise you have to muck with yaml a bit
You have to build this cicuit, per channel. But do it after 5v pwm is tested. You'll need npn transistor, 1K & 10K resistors, 10V power supply.
Exactlly! Im learning too.
Last time i checked your configuration was wrong, use `jacks` instead of `channels`. I have shared example couple of posts before. Can you share the current config file ?Still nothing. I do have 5volts now from ground to v+ but no output on pwm
Whoa :-) congrats. :-) Pics ??
Check the logs,, what the log says? it should mention about what values of pwm its setting (o-100) and against what pin. If thats correct, we have some serious bug or wrong wiring
Configuration file.
Because the configuration format has changed, I believe his settings are not propagated, i.e pwm is enabled but there is no channel (they have been renamed as jacks)
I have rewritten the whole UI/Configuration -> pwm code path recently :0/ , as part of a major dynamic lighting implementation.
So this affects all prior builds? I have had reef-pi down a couple days as I am doing some rewire work.
