- Joined
- May 19, 2017
- Messages
- 367
- Reaction score
- 443
Hi.
I have a Reefer 250 with the V3 sump and I wanted to swap the red sea valve with a gate valve and these are the parts I needed and pics of what I did.
A. CoralVue PVC-CPLG-32 32mm Metric Standard Coupling (Purchased from CoralVue)
B. CoralVue 32mm to 1" Metric to Standard PVC Adapter (Purchased from Bulk Reef)
C. 1” Spears Gate Valve Slip x Slip (Purchased from Bulk Reef)
1” Schedule 80 Pipe Grey 46" length (Purchased from Bulk Reef)
I cut the pipe into a 2inch piece to fit between B and C, and a 16in piece to go out the bottom into the sump.
I also had to move the pipe holder down a bit. I didn't know if there was an easier way to do this but it worked out great.
I cleaned up the rough edges with a file and used Oatey grey PVC cement no primer.
I have a Reefer 250 with the V3 sump and I wanted to swap the red sea valve with a gate valve and these are the parts I needed and pics of what I did.
A. CoralVue PVC-CPLG-32 32mm Metric Standard Coupling (Purchased from CoralVue)
B. CoralVue 32mm to 1" Metric to Standard PVC Adapter (Purchased from Bulk Reef)
C. 1” Spears Gate Valve Slip x Slip (Purchased from Bulk Reef)
1” Schedule 80 Pipe Grey 46" length (Purchased from Bulk Reef)
I cut the pipe into a 2inch piece to fit between B and C, and a 16in piece to go out the bottom into the sump.
I also had to move the pipe holder down a bit. I didn't know if there was an easier way to do this but it worked out great.
I cleaned up the rough edges with a file and used Oatey grey PVC cement no primer.