- Joined
- Jul 17, 2019
- Messages
- 22
- Reaction score
- 8
- Location
- Ontario
- What state or country do you live in
- Canada
Hi All,
So I made my first attempt at re-sealing my tank that I bought used. I first cleaned all the old silicone out, including any residue left behind, using a vinegar water mix, scubbers and razors. Once all clean I taped off the thickness, being a 210 gallon, I did a 1/2" spacing, then I laid the silicone down, I had a fan going because it was inside, but that seemed to start drying it too quickly, because when I went to smooth the section out with a corner tool, it was pulling and leaving a very rough looking finish, also when I pulled the tape off it left marks in the silicone and pulled up a couple edges.
My question can I apply more silicone over top (it has been a couple days) ? Or would I need to cut out the bad sections and re-apply?
Thanks in advance for any advice.
Jesse
So I made my first attempt at re-sealing my tank that I bought used. I first cleaned all the old silicone out, including any residue left behind, using a vinegar water mix, scubbers and razors. Once all clean I taped off the thickness, being a 210 gallon, I did a 1/2" spacing, then I laid the silicone down, I had a fan going because it was inside, but that seemed to start drying it too quickly, because when I went to smooth the section out with a corner tool, it was pulling and leaving a very rough looking finish, also when I pulled the tape off it left marks in the silicone and pulled up a couple edges.
My question can I apply more silicone over top (it has been a couple days) ? Or would I need to cut out the bad sections and re-apply?
Thanks in advance for any advice.
Jesse
