1) I had to order the pressure pump as I was only getting 30 pounds of pressure. Questions: Maybe I am an idiot but how do you use that tool to get the murlock connectors off? As you can see from the video I put couplers to have the water flow through the pump correctly, it was late and I simply gave up, I just can't get them apart. Next Q: I noticed the last 3 water changes I have gotten diatoms and then they would go away, almost like clockwork. With the low pressure could silicates have been slipping through? Or, is the stage 4 kit not good at catching silicates? I was thinking about adding this to my system - Dual DI Phosphate CO2 & Silica Eliminator with DM-1 Dual TDS Meter, thoughts?
2) Check out the video. My Brute container filled up and the float shut the switch off. But the pressure switch never shut the motor down. In fact, it sounds like this mustang I use to have after I put a really sick cam in it, miss that car... Could I have put the switch in backwards? Those dang murlocks, and I have no more couplers! What am I doing wrong? Also, I will make it look better, but just trying to do a dry run to make sure it's good to go and then I will make it all nice. Thoughts?
2) Check out the video. My Brute container filled up and the float shut the switch off. But the pressure switch never shut the motor down. In fact, it sounds like this mustang I use to have after I put a really sick cam in it, miss that car... Could I have put the switch in backwards? Those dang murlocks, and I have no more couplers! What am I doing wrong? Also, I will make it look better, but just trying to do a dry run to make sure it's good to go and then I will make it all nice. Thoughts?