Sensor historical data logging not showing up on touch

[HippieSmell]

Not sure why

 

[Support@GHLUSA Verified Sponsor]

I'm not either
.
.
.
.
.
.
.
.
.
.
.
.

But maybe you could help us help you, by providing some information...
P3/P4 ?
Firmware of ProfiLux
Firmware of Touch

Sensors selected to record, what do they show, screenshot of what it shows?

 

[HippieSmell]

Sorry, was in a rush when I posted.

It's P3.1 T EX, firmware 6.29.

Touch firmware 1.06

pH, temp, conductivity, and redox are recording. Nothing is showing on the graphs.

Thanks!

 

[HippieSmell]

Any help with this, please?

 

[HippieSmell]

Little help? Graphs show up in control center, but not the touch. Touch is connected to Vortech module, which is connected to a power strip.

 

[Support@GHLUSA Verified Sponsor]

Can you post a picture of what your graphs show?
Is your touch assigned as a PAB device? Did you change the default range of each sensor in the touch ?

 

[HippieSmell]

Can you post a picture of what your graphs show?
Is your touch assigned as a PAB device? Did you change the default range of each sensor in the touch ?

No screenshots, but there isn't much to show. The graph shows up with the correct range, but there's no plotting. The touch is also assigned as a PAB device.

I have had some of the plots show up before, but they weren't continuous and now it's just stopped showing anything.

 

[HippieSmell]

Still waiting for help, or should I go somewhere else?