just take the ones you have to shop,have them order new ones...
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
I was thinking about slip for bothYou know your size. Do you need slip or threaded on the flange side, slip or threaded on the tail side?
I don't have any shops close that do that. The closest fish store that I could go to is an hour plus away.just take the ones you have to shop,have them order new ones...
Starting to get excitedYes those bulkheads will work. You'll also want a gate valve for the primary on both sides
You should be. It's fun.Starting to get excited
One's easier to close quickly, one get your finer adjustment. Six of one half dozen of the other I think.i normally put balls on drains,in case i want to shut down for any reason,
yes gates or balls on returns , wiwd...
When it is all set up will it be hard to have access to the bulkheads? And your holes will not take sch80 bulkheads anyways so that's not really an option unless you wanted to step down in size but even then it's not a good ideaBulk heads in cart. They are 1 inch slip ×slip. Sleeping on it really thinking of slip and thread. I like the quick disconnect.
Was looking at the 80s after reading the Abs should be fine and the 80s are way over kill.
Also going herbie drains. I like the ease of fine tuning for noise reduction. The returns will be over the back.
Do I wake the sleeping beauty. Not a chance. Will have them ordered tomorrow.
It was set up as 2 dorso and 2 one inch returns. I was thinking herbies to make it quieterWhen it is all set up will it be hard to have access to the bulkheads? And your holes will not take sch80 bulkheads anyways so that's not really an option unless you wanted to step down in size but even then it's not a good idea
Honestly no need to run dual one inch herbie drains, I don't believe you plan on running 2500+ GPH through your sump but I may be mistaken. If you want the returns can be run using two of the 1 inch pipes in the overflows. Just trying to keep your options open