Skimmer not Bubbling

ReefGirl87

Active Member
View Badges
Joined
Jan 27, 2020
Messages
416
Reaction score
334
What state or country do you live in
Michigan
Rating - 0%
0   0   0
I have an OctoReef 110 INT skimmer that’s been running In my sump for about 2 weeks. It was producing nasty green skim for a few days into the collection cup and now today it isn’t producing many bubbles at all. Not sure what’s going on. Any suggestions?
 
I have an OctoReef 110 INT skimmer that’s been running In my sump for about 2 weeks. It was producing nasty green skim for a few days into the collection cup and now today it isn’t producing many bubbles at all. Not sure what’s going on. Any suggestions?
You may need to make an adjustment. Turn it up or down and see what happens.
 
hi poss block in venturi ,or pump intake octo's need to prime for air by capping when restarting
 
hi poss block in venturi ,or pump intake octo's need to prime for air by capping when restarting

Mine never has a problem except when dirty. Of course the design of the Venturi requires frequent cleaning. Like monthly soaking in vinegar and scrub with a toothbrush cleaning.

I’m thinking of only running mine for 6-8 hours a day on the new tank so I hope I can get it to frequently restart without priming the air when I put it on my apex
 
Check pump at intake
 
turn the skimmer on full blast (fully open the gate valve) and put your finger over the air intake until the water level goes all the way up and begins to overflow, do this until no more bubbles are left in the skimmer. remove your finger and all should be good!
 
turn the skimmer on full blast (fully open the gate valve) and put your finger over the air intake until the water level goes all the way up and begins to overflow, do this until no more bubbles are left in the skimmer. remove your finger and all should be good!
Ok, I will try that, what exactly does that do?
 
Skimmer performance is affected by introduction of amino acids, epoxy, superglue, fish food.... The list goes on and on. Typically the skimmer will perform normally in a few hours or a couple days based on what you added and how much of the item you added.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new