Skimmer Q&A Thread
- Thread starter mojo
- Start date
- Tagged users None
WrasseSandwich
Active Member
anyone have opinions on the Super Reef Octopus XP 1000 SSS ??
cichlidtx
Active Member
mojo, my SWC150 bmk keeps overflowing. Do you have some input on why this may keep happening. I setup it up at 8" deep in the sump. Can you shed some light on how you dial this in and any other advice would be appreciated.
kuyatwo
Well-Known Member
Mojo
I am upgrading from 65 gallon to a 140 gallon. I currently run an I tech 100. I was thinking on going I tech 200 or the new ati power cone skimmer when it comes out. What's your opinion on itech skimmers compared to other skimmers you have tested and what skimmers would you also recommend.
I am upgrading from 65 gallon to a 140 gallon. I currently run an I tech 100. I was thinking on going I tech 200 or the new ati power cone skimmer when it comes out. What's your opinion on itech skimmers compared to other skimmers you have tested and what skimmers would you also recommend.
kracer1025
Active Member
Mojo,
I have a 100 Gallon sps tank with a fairly heavy bioload. If you had a choice between the new ATB Elegance 200 or the Bubble King Mini 160 which would you choose. Or is there another skimmer that you would recommend for this size of tank. I have a 35 gallon sump and my skimmer section is 14x14.
Thanks
I have a 100 Gallon sps tank with a fairly heavy bioload. If you had a choice between the new ATB Elegance 200 or the Bubble King Mini 160 which would you choose. Or is there another skimmer that you would recommend for this size of tank. I have a 35 gallon sump and my skimmer section is 14x14.
Thanks
OP
OP
the 100 is fine for what you have but will be too small for the 140. The 200 would be fine but the ati 160 would be good the atb 840, the sro 2000 vertex in 180 would all work well on the 140 too. if you are happy with the itech then getting another would be less scary. Make sure you get te tunze pump. it makes the skimmer.
OP
OP
Thats really tough. I like them both and the elegance is a great skimmer. But the ease of use of the mini 160 is hard to beat.
The 160 pulls about 700 lph of air where the elegance pulls 1300 lph. honestly the elegance will need a pretty heavy loaded 100 to perform well. the 160 I would say works best from 75 to 125g reef tanks. where the elegance would range from 100 to 200 gallons. if that helps
OP
OP
where is the air valve set ? make sure its all the way open. Not sure why swc adds these air valves. kind of a pain really.
Open the wedge pipe so the water level is just below the taper going to the neck. Let it sit there for a day. then make very small adjustments.
cichlidtx
Active Member
I have the air valve almost all the way clockwise. Is clockwise all the way open? I had the water level at the base of the of cup. I will lower it to the taper and if you will let me know on the air valve setting. Thanks again for the help.
kracer1025
Active Member
Mojo,
Thanks for the reply. What if I take the Elegance out of the running and add the Vertex Alpha 170. The Alpha would give me a bit better contact time I would think with the external pump, or would you still choose the mini 160.
Thanks for the reply. What if I take the Elegance out of the running and add the Vertex Alpha 170. The Alpha would give me a bit better contact time I would think with the external pump, or would you still choose the mini 160.
I have an Octo Extreme 160 with the awesome Sicce 2500 and it's getting way to loud for my liking. I was wondering if anyone could recommend a replacement pump? I'm looking into the Sicce Syncra pump and would like to stay in the $100-$150ish range but main thing is it needs to be silent and fit under the skimmer... I'm thinking of spending the money and getting the Eheim 1103 pump because of all the reviews...
Any input is greatly appreciated...
Any input is greatly appreciated...
Last edited:
slice
Active Member
General Skimmer settings question (skimate)
Great thread!
I have a CPR Aquafuge II PS, a Bak-Pak skimmer integrated into a HOB refugium. I don't have any personal experience with any skimmer except this one. I have switched out the original Rio 600rv for the Accela pump, which is much more powerful and seems to be doing a much better job.
I empty from 1/4" to 1/2" (sometimes more) medium dark green "tea" from my cup twice a day; before leaving from work, again when I get home. There is sludge buildup in the neck and on the underside of the cup cover that is cleaned once a week. I feel all warm and fuzzy inside whenever I empty the cup, knowing that crap is no longer in my tank.
I run the venturi air line wide open most of the time. It is noisey.
I've read that "wet skimming" is "aggressive" skimming, which is what I want...I think...(?)
My meager google skilz has not found the answer to my question:
What should I try to set my cup level for? Wet skimate or drier sludge? What are the advantages/consequences of both?
Thanks in advance!
EDIT
Wouldn't you know it, just after I post this, I get good hits from googling "wet versus dry skimming"...I still would like your thoughts.
Great thread!
I have a CPR Aquafuge II PS, a Bak-Pak skimmer integrated into a HOB refugium. I don't have any personal experience with any skimmer except this one. I have switched out the original Rio 600rv for the Accela pump, which is much more powerful and seems to be doing a much better job.
I empty from 1/4" to 1/2" (sometimes more) medium dark green "tea" from my cup twice a day; before leaving from work, again when I get home. There is sludge buildup in the neck and on the underside of the cup cover that is cleaned once a week. I feel all warm and fuzzy inside whenever I empty the cup, knowing that crap is no longer in my tank.
I run the venturi air line wide open most of the time. It is noisey.
I've read that "wet skimming" is "aggressive" skimming, which is what I want...I think...(?)
My meager google skilz has not found the answer to my question:
What should I try to set my cup level for? Wet skimate or drier sludge? What are the advantages/consequences of both?
Thanks in advance!
EDIT
Wouldn't you know it, just after I post this, I get good hits from googling "wet versus dry skimming"...I still would like your thoughts.
Last edited:
toejam
Active Member
Hey mojo, would upgrading my sedra 9000 pump on my wm s200 to a sedra ho 9000 be worth it? MD has the modded pumps as replacement pumps for the aquamaxx am250. Get a new pump or replace it with the new aquamaxx am250 skimmer?
I do have 340g of water, maybe the am500, yaaa.
I do have 340g of water, maybe the am500, yaaa.
OP
OP
it would allow more flow and air. from 600 lph to 1000 but you have t change the elbow and the inlet going into the body. not an easy task by anymeans. your skimmer isnt bad. the am am 250 is a little more current and will perform slightly better.
OP
OP
Had to update my list up top a little. I think I am caught up for now. but if anyone has any question just let me know. I get a ton on the other forums but would rather answer them here. less political and well its a Q&A forum not a debate. lol. Have a good weekend ...
Mojo~
Mojo~
Similar threads
TOP 10 Trending Threads
-
- Sticky
