Built a stand for a new 75G I'm setting up, and I picked out the truest flattest wood I could.
However, after now that the tank is on top, I notice quite a few spaces in-between the trim and the plywood that are not touching. 1/16th inch gaps in several different areas.
The outside of the plywood is held to the frame by 12 screws lol so I'm not sure if water weight is going to flatten it out..
Am I just being paranoid? What should I do?
However, after now that the tank is on top, I notice quite a few spaces in-between the trim and the plywood that are not touching. 1/16th inch gaps in several different areas.
The outside of the plywood is held to the frame by 12 screws lol so I'm not sure if water weight is going to flatten it out..
Am I just being paranoid? What should I do?