System shock= GHA bloom/cyano

  • Thread starter Thread starter legacy2mj
  • Start date Start date
  • Tagged users Tagged users None

legacy2mj

Active Member
View Badges
Joined
Jun 28, 2014
Messages
406
Reaction score
135
Location
Lone Tree, Colorado
Rating - 0%
0   0   0
Long story short.. Iv been of moonshiners for a while, thought I was going to have to move out of state temporarily. I didn’t want to leave daily dosing and moonshine method to anybody looking after the tank.
so I switched to ESV B-ionic 2 part for simplicity, this also brought along water changes..

7 year old system, SPS dominant. Havnt had algae issues in years.

Now it’s out of control, I contribute to the swap In method cause there’s no indicator.

Parameters
Alk-9
Cal-430
Mag-1375
Ph- 8.2
No3- 8.0
Po4- 0.06
Temp- 78.6
Salinity 1.026
 
Sounds like your rodi might have let some stuff through… I don’t think anything else would have shocked the system or caused that.
 
Sounds like your rodi might have let some stuff through… I don’t think anything else would have shocked the system or caused that.
I run 2 sediment filters, 3 carbon blocks, 3 High capacity resin blocks: and 2 membrane…. My Rodi isn’t the issue: … none of my parameters equal a source for such a massive outbreak. I’m at a loss
 
I run 2 sediment filters, 3 carbon blocks, 3 High capacity resin blocks: and 2 membrane…. My Rodi isn’t the issue: … none of my parameters equal a source for such a massive outbreak. I’m at a loss

Might be some trace element was needed and water changes supplied it, or it might be coincidence.
 
Might be some trace element was needed and water changes supplied it, or it might be coincidence.
For GHA and cyanos the trace element is most likely iron. ICP may not find iron in the water but GHA and cyanos also grow on precipitates. They may even get phosphate and iron from precipitates at the same time.
 

IF YOU HAD TO OPERATE EVERYTHING ELSE MANUALLY, WHICH AUTOMATED SYSTEM WOULD YOU KEEP?

  • Auto top-off

    Votes: 41 59.4%
  • Automated dosing

    Votes: 5 7.2%
  • Mechanical filtration / roller filter

    Votes: 4 5.8%
  • Automated water testing

    Votes: 3 4.3%
  • Automatic feeding

    Votes: 0 0.0%
  • Lighting schedule

    Votes: 9 13.0%
  • Controller and remote monitoring

    Votes: 3 4.3%
  • Leak detection and emergency shutoff

    Votes: 1 1.4%
  • Automatic water changes

    Votes: 2 2.9%
  • None. I prefer to operate everything manually

    Votes: 0 0.0%
  • Something else (explain in the comments)

    Votes: 1 1.4%
Back
Top
Home
Post thread…
Market
What's new