TANK NOT LEVELLED

It comes with a level mat built into the table I guess this would solve this problem right ?
That’s for support not level. The only real risk is more to the stand than tank. You said it’s ~0.75” off level. That’s less than 1 degree. The asymmetric force applied to one side of a tank is fractional to that. The amount of damage you are risking is in the noise. Walking near your tank or loud thunder probably does more damage. It’s just going to annoy you until you fix it.
 
The level mat just redistributes minor irregularities between the glass and the stand. It won't change the level. Only way you can fix the unlevel tank is to raise the foot of the stand. Make sure you don't raise one foot more than the other of the pair, this will cause warping of the supporting surface. This it the most damaging to the structure of the tank.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 15 18.1%
  • Fish or coral food

    Votes: 5 6.0%
  • Test kits or reagents

    Votes: 8 9.6%
  • Filter media or replacement fleece

    Votes: 4 4.8%
  • RO/DI filters or supplies

    Votes: 13 15.7%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 12.0%
  • I keep a backup of everything

    Votes: 21 25.3%
  • Other (Post in the comments)

    Votes: 7 8.4%
Back
Top
Home
Post thread…
Market
What's new