Tank stand - is this something to be concerned about?

[BriansBrain]

I noticed this wood joint looking to be separating. Is this something I should be concerned with? Stand is a maple stand from Planet Aquariums and about 5 years old. Thank you

 

[TX_REEF]

Is there a frame behind that or is it structural? If that’s structural, I’d be concerned

 

[BriansBrain]

Is there a frame behind that or is it structural? If that’s structural, I’d be concerned

Tbh I’m not sure how structural it is. Appears to be an exterior trim piece that is miter jointed. Water is obviously getting into the joint. However, the tank is sitting on it along with the tank’s seam.

Here’s a picture of the inside of that corner that looks ok

 

[TX_REEF]

I think it should be ok because there is a vertical support at the corner and sheet lumber on top. Maybe add a metal L bracket on the corner or both front corners so it’s supported and looks symmetrical?

 

[BriansBrain]

I think it should be ok because there is a vertical support at the corner and sheet lumber on top. Maybe add a metal L bracket on the corner or both front corners so it’s supported and looks symmetrical?

Thank you. I also thought to be extra safe and emailed planet aquariums. Things like that keep me up at night

 

[FinalMac]

I don't think you have anything to worry about Because it looks like it's just the facade, but if you're really concerned, they make small corner, Jack stands that could go inside there and easily support it. You don't have to lift up on the tank, just make it tight.