How long do you acclimate and how do you keep the water in the bucket warm?
Do you drain the bucket partially during acclimation? I'd imagine you couldn't get all the way up without doing that at least once. 50% 1.019 (example of fish shipment)+ 50% 1.025 (example of qt or reef) doesnt equal 1.025 obviously.
I have everything in my fish room so the temp was fairly high. Temp of the room is set at 75 and tank is set at 77.
I use an air line with a rigid tube bend to a hook at one end and a air control valve at the other end to control water flow rate. I just drip water to the bucket, and remove water from the bucket as needed. I have new salt water mix ready all the time so I just replace water to the tank from this.
How fast I want to raise the water is control by how much water I leave in the bucket and how fast the flow rate is. With the same flow rate, obviously 1 gal will increase salinity much faster than 3 gal. For the three Potter Wrasse, I had 3 hrs to work on them so I tried to increase salinity from IIRC 27 ppt to 35 ppt over about 1 hr. They did fine. I just fly by the seat of my pants here, don't have an exact protocol that I use. I didn't add many fishes to my tank for many years.
I keep remove the water from the bucket and check salinity off and on. Once it is the same then I just scoop the fish over to my QT. I did not keep tract of how much water I use but it must be about 10 gals or so. Once the fish all transferred to the bucket, I usually leave about 1.0-1.5 gal in it. The air stone keep the water super saturated with O2 and keep the water circulate. I use refractometer to check salinity. Once the water in the bucket was replaced 3-4 time, the salinity is exactly the same.
BTW, evaborated water replacement (saturated Kalk solution) add to my tank with a pump at a constant rate. I don't use flow valve so as I remove water from the tank, I don't have to worry about the tank water get diluted with Kalk solution. I replace the water to the tank at a time at the same time as I empty the water from the bucket. If you use flow valve, you need to worry about this. Perhaps add water to the tank first so that as the water level drop, it does not trigger fresh water dump into your tank.
Last edited:
