BestMomEver
2500 Club Member
Did an ICP test on my well water. This is what I got. This seems just as good as water from an RO/DO unit! Pay no attention to the pink notifications. I registered this sample as an aquarium test by accident.
This is what I drink.
- Thread starter BestMomEver
- Start date
- Tagged users None
Brew12
Electrical Gru
That is pretty good. The phosphorus and silicon are a bit higher than I would like to see but its not as bad as could be expected.Did an ICP test on my well water. This is what I got. This seems just as good as water from an RO/DO unit! Pay no attention to the pink notifications. I registered this sample as an aquarium test by accident.
I'm wondering if I should be shocked at 0.02ppm uranium... :confused:
OP
OP
BestMomEver
2500 Club Member
Ha! I don’t know. But I compared my water to saltwater (Fiji) and I have less uranium in my water than the ocean. Go figure. I tested my water to see if I could quit buying water from the LFS. I am gonna buy a DI unit... no RO necessary... and filter some stuff out. But I’m gonna save myself some money. Good old tap for me!
link81
Well-Known Member
9ppm chlorine from your well is somewhat concerning.
cdc seems to think about .5ppm is a "normal" level for city water.
i'm sure someone here knows better though.....
https://www.cdc.gov/safewater/chlorine-residual-testing.html
cdc seems to think about .5ppm is a "normal" level for city water.
i'm sure someone here knows better though.....
https://www.cdc.gov/safewater/chlorine-residual-testing.html
OP
OP
BestMomEver
2500 Club Member
Oh yea.... chlorine neutralizer. I need that. But still, the ICP reference shows my chlorine lower than that in natural seawater.
link81
Well-Known Member
very true. is the test testing chloride or chlorine gas? any idea? maybe it doesn't know the difference....
i should get around to sending mine out as well, i can only imagine whats in my water......;Nailbiting
OP
OP
BestMomEver
2500 Club Member
It’s eye opening. I use RO/DI water that I purchase in my tank and my husband uses tap water in his. Hubby’s tank has been covered in hair algae for a year. I keep telling him that his algae issue is due to his using tap water. But now I’m preparing to set up a 90 gallon tank and the thought of buying and hauling 50 gallons of water is not fun. So, I sent off a sample of my water to see if I could just drag the hose inside. Gladly, I feel comfortable that I can do that. A little Prime in the water and I’m good to go! And now I know that hubby has poor husbandry methods. Actually, that’s not true. He just has very little time.
Last edited:
What are you referencing for natural sea water parameters?
OP
OP
BestMomEver
2500 Club Member
I think there is uranium in everyone’s water for the most part. It’s found everywhere. If I weren’t very smart, I’d blame you for my uranium... I’m in Mobile... just down the river a bit. ;)
OP
OP
BestMomEver
2500 Club Member
The ICP test compares the test sample to the results of water from Fiji. I haven’t looked at anything else. No doubt different oceans (and different areas of the same oceans) have different water. And I’ve never compared the test company’s Fiji water to anything official.
dantimdad
7500 Club Member
Yes, there is. But, I saw a water analysis done by a large power company near their facility. ;)
silicon is that similar/same as silicates that everybody talks about?
this sounds almost counter intuitive to me. seems like you could potentially burn through Resin, trying to save some money when the RO membrane and filters could block some of that. I think i would take tds meter and see what the tds is from faucet.
this sounds almost counter intuitive to me. seems like you could potentially burn through Resin, trying to save some money when the RO membrane and filters could block some of that. I think i would take tds meter and see what the tds is from faucet.
dantimdad
7500 Club Member
Yep. This. A membrane would last a long time for you and make the resin last a ridiculous amount of time as well.
OP
OP
BestMomEver
2500 Club Member
You’re probably right. But here’s the thing. My husband is a chemist and the quality manager at a large chemical plant. He’s my local expert. He seems to think that the DI is all that’s necessary. It will get rid of stuff we need to get rid of without having to pass water through a membrane. We would also be able to avoid a lot of waste water too.
OP
OP
BestMomEver
2500 Club Member
The DI unit I ordered has a built in TDS meter.
dantimdad
7500 Club Member
Waste water is a huge issue with me. I went with a booster to minimize it. Before the booster it was insane how much was getting rejected.
I wish I could do without the RO portion all together.
I wish I could do without the RO portion all together.
Gotcha, I didn’t know how that worked. Is there a chart showing Fiji results you could post?
OP
OP
BestMomEver
2500 Club Member
Here you go!
I’d have to highlight each element to show each comparison but that would require 40+ pictures. Is there a particular one you’re interested in?
Similar threads
