Tunze 6095 Help

[skrork]

If I set the Constant mode to 100%, shouldn’t the pump just run continuously? If so, mine is not doing this.

With one timeslot set to run constant at 100%, yes, it should be permanently on.

Thanks for the confirmation. Something is wrong then.

 

[areefer01]

Thanks for the confirmation. Something is wrong then.

You may have already said this but are you on the latest firmware?

Also have you tried to unplug it, wait for a minute then plug it back in and see if that changes anything?

Also have you reached out to Tunze? Should be able to contact support. I've done that when I had a question and they got back within a day if I remember correctly.

We can also try and tag @skrork (Tunze).

 

[skrork]

Thanks for the confirmation. Something is wrong then.

You may have already said this but are you on the latest firmware?

Also have you tried to unplug it, wait for a minute then plug it back in and see if that changes anything?

Also have you reached out to Tunze? Should be able to contact support. I've done that when I had a question and they got back within a day if I remember correctly.

We can also try and tag @skrork (Tunze).

Yes, running the latest firmware (1.4.3).
When I change programming in cloud or manual mode, the controller will reflect the programming based on the flashes and percentage levels, but the power head itself seems to not be willing/able to run for extended periods.

The fast pulse setting that was suggested to try in an earlier post does work, until I try to extend the pulse length. As noted earlier, it will not run in constant mode in manual or cloud mode. It will run for about 3 seconds or so, then stop. About 30 seconds later it will run for 3 seconds or so.

I appreciate all the assistance from all of you.

 

[Blue Ring Octopus]

For all of these reasons above I will stick with the old school 6095 with the knob turn.

 

[minus9]

I think this is a rare issue with these pumps. I have 5 hub edition pumps and all work perfectly, so I would reach out to Tunze support and @rvitko will help get this resolved.